mysoda Toby - Page 4

6 7
NOTE: The device can use 60 litre and 130 litre CO2 cylinders. 130 litre cylinders are available on a
limited basis and only in certain countries.
INSTALLING THE CO2 CYLINDER
CHANGING THE
CO2 CYLINDER
After the CO2 cylinder is
empty, replace the CO2
cylinder in the same way as
the first time you installed
the cylinder.
1. Remove the water bottle
by pulling the bottle and
carbonation nozzle towards
yourself, and then unscrew it
(one quarter clockwise).
3. Unscrew the black
thread protective cap on
the top part of the device
body.
4. Remove the seal and cap
from the CO2 cylinder.
5b. Carefully insert the top part to
the bottom part. Turn the top part
clockwise until it clicks into place.
2. Uninstall the top part of
the device body by turning
it anti-clockwise.
5a. Install the CO2 cylinder by
screwing it clockwise. Attach the
cylinder firmly enough, but do not
tighten too much.
6b. If you are using a 130 litre CO2 cylinder, turn over the adapter on the
bottom of the unit, so that you can install a larger cylinder.
6a. Carefully insert the CO2 cylinder
and top part together to the bottom
part. Turn the top part clockwise until
it clicks into place.
EN
1
2
Installing 60L CO2 cylinder:
Installing 130L CO2 cylinder:
1
2
1
2
HOW TO MAKE SPARKLING WATER
3. Push the carbonation button 2–3 times,
stop when you hear a hissing sound.
4. Pull the bottle towards yourself to release pressure
inside the bottle.
6. Enjoy your carbonated water or add desired
flavour.
5. Release the bottle by turning it by one
quarter clockwise.
1. Fill the water bottle with cold water up to the
fill line.
2. To insert the water bottle, make sure that the device
is in a fully upright position and the bottle quick-lock is
angled forward. Then insert the bottle in quick-lock and
turn one quarter anti-clockwise to lock. Push the bottle
towards the device to a vertical position.
NOTE: Only use compatible CO2 cylinders and Mysoda water bottles. Never carbonate if
the bottle is empty, not fully inserted with water or if water is above the fill line.
1
2