MODEL DESCRIPTIONS/ SETUP
HP60/ HP100/ K100HP
These machines are equipped with a 100-psi pump, a 3 stage vacuum motor and
a 1200-watt heating system. They are a single power cord unit. The power cord is
a 25' 12-3 cord. Each unit draws about 19 amps. (115v) To run effectively, use a
dedicated 20-amp outlet. The HP100 has 11 gallon solution and recovery tanks.
The K100HP has 9 gallon solution and recovery tanks. The HP60 has 6 gallon
solution and recovery tanks.
NOTE: All units come equipped with a 15' vacuum hose and a 15' high pressure,
high temperature solution hose along with a 3" stainless steel upholstery wand.
SET-UP
1. Your machine comes with two metal brackets. These can be installed on the
sides of the machine. Simply remove the screws with a Phillips head screw-
driver and place the bracket over the 2 brass inserts. Thread the screws in
the inserts and tighten with the screwdriver. Use the brackets for holding
your hose and hand tool so they do not have to lay on the floor. Also, the
bracket can be used to hold your Versa-Tool polisher.
2. You will find a black plastic 45-degree elbow inside the machine. Place this
elbow on the drain valve on the rear of the unit. The elbow will direct the flow
of recovered water downward.
3. Plug in yellow electrical cord into a dedicated 20-amp circuit outlet.
4. Fill solution tank with water, and add 1/2 cup of rinse additive.
5. Attach vacuum and solution hoses to appropriate connections on the machine
and your wand. Make sure the quick disconnects snap together firmly. As you
do this, always inspect hoses for cracks or fraying. Do not use if hoses are
damaged.
6
To Next Page
Loading...
