Need help?Do you have a question about the MyTek Stereo 192-DSD and is the answer not in the manual?
General| Sample Rate | Up to 192 kHz |
|---|---|
| PCM Sample Rates | 44.1kHz, 48kHz, 88.2kHz, 96kHz, 176.4kHz, 192kHz |
| Supported Formats | PCM, DSD |
| Outputs | Analog |
| Dynamic Range | 120 dB |
| DSD Support | DSD64, DSD128 |
| Digital Inputs | USB, S/PDIF |
| Analog Outputs | RCA, XLR |
| Power Supply | External |
| Type | Digital to Analog Converter |
| Inputs | USB, S/PDIF |
| THD+N | <0.001% |
Controls volume and navigates menus.
Enters or cancels the main menu.
User assignable, defaults to Input Selection.
Shows volume and sample rate.
Indicates signal's digital level (black front panel only).
User programmable, defaults to Mute.
High-current headphone amplifier output.
Powers the unit on or off.
Standard power input with fuse.
Consumer digital input up to 192KHz.
Hi-speed computer interface, 192KHz/DSD capable.
Hi-speed computer interface, 192KHz/DSD capable.
Full speed computer interface, 96KHz capable.
For professional clock distribution, 192KHz capable.
Consumer digital input up to 96KHz.
Professional digital input up to 192KHz.
Analog input available on Preamp version only.
Unbalanced stereo analog output.
Balanced stereo analog output.
Selects the digital or analog input source.
Configures PCM upsampling to 192kHz.
Adjusts PCM and DSD filtering characteristics.
Details analog, digital, and bypass volume control.
Sets 0dB VU reference in dBFS.
Assigns functions like Mute, Phase, Mono, L-R.
Assigns functions like Mute, Phase, Mono, L-R.
Configures Apple or RC5 remote control.
Adjusts brightness and auto-off settings.
Displays firmware version and allows factory restore.
Shows status of selected input sources.
Indicates upsampling status for PCM/DSD.
Shows active filter settings.
Indicates volume control mode (Analog/Digital/Bypass).
Shows selected volume trim level.
Displays status of Fn1 button assignments.
Displays status of Fn2 button assignments.
Shows remote control mode (Apple/RC5).
Indicates display settings like Brightness, Auto Off.
Shows firmware status (Version, Restore).
Detailed description of each input type.
Explains PCM upsampling to 192kHz.
Details Internal, Input, and Word Clock sync.
Explains Analog, Digital, and Bypass volume control.
Sets 0dB VU reference in dBFS.
Assigns inputs to Fn1/Fn2 buttons.
Mutes audio output.
Inverts the audio signal phase.
Sums left and right channels to mono.
Subtracts one channel from the other.
Combines Mono and L-R for stereo processing.
Instantly lowers volume by 20dB.
Controls LED display brightness and auto-off.
Enables and configures remote control.
Displays firmware version and restore option.
Plug-and-play setup for USB 1.1.
Step-by-step guide for USB 2.0 driver install.
Ensures bit transparency for DSD playback.
Procedure to remove the USB driver.
Switch between 115V and 230V power.
Jumpers to lower output level by 6dB.
Steps to pair an Apple Remote.
Steps to configure RC5 compatible remotes.
Lists functions assignable to buttons and menu options.
To Next Page
