4.) Display will not illuminate
(1) Electrical connection - Please disconnect main power cord and connect again.
(2) Voltage supply - Please check to voltage.
(3) Check the fuse
(4) Verify voltage on the serial number label of the machine
(5) Defective power switch (check voltage at switch)
III-4. Maintenance:
The platform of Mini shaker with remote control should be cleaned regularly with a
soft cloth dampened with water or alcohol. (Always ensure that the machine has
been powered down prior to cleaning.
In the event of a spillage: Power down the unit, remove the platform and dry the internal
chamber with a soft cloth. DO NOT attempt to operate the unit until the spillage had been
properly dried.
IV-4. Service and Contact
Service on Mini shaker with remote control should only be performed by qualified service
personnel. To request service or technical support, please contact N-BIOTEK or your
local N-BIOTEK representative.
Ph: +82-32-321-2100
Fax: +82-32-328-2372
Em: export@n-biotek.com
Web: www.N-BIOTEK.com
P.O. Box 402-803 Techno-Park, YakDae-Dong, WonMi-Gu, BuCheon-Si,
GyeongGi-Do, Korea Rep.
To Previous Page
Loading...