14
Single Battery Module Connection
1. Insert the supplied signal cable into the extension port ( P1 or P2 ).
*It's requested to connect to the battery module for normal operation.
2. Use supplied battery cable to connect to power module via CON1 or CON2.
3. Insert the supplied RJ45 cable into the COM port on the battery module. The
other end connects to BMS communication port on the power module.
Power Module
❸
❷
Battery module
❶
*Insert signal cable into the extension port or .
4. Turn the breaker switch “ON". Now, the battery module is ready for DC output.
5. Press manual ON/OFF button for 5 secs, the battery module will start up.
*If the manual button cannot be approached, just simply turn on the power
module. The battery module will be automatically turned on.
To Next Page
Loading...
