16
4. Insert supplied RJ11 cable to connect the extension port of the Master battery
module #1. The other end connects to the extension port of the battery
module #2.
5. Use supplied battery cable to connect to the Master battery module #1 and
battery module #2.
6. If more battery modules to connect the system, repeat step 4 and 5 to connect
more battery modules.
7. After connecting all battery modules, turn the breaker switch “ON" of each
connected battery module. Now, the battery modules are ready for DC output.
8. Press manual ON/OFF button of each connected battery module for 5 secs. All
battery modules will start up.
*If the manual button cannot be approached, just simply turn on the power
module. The battery module will be automatically turned on.
To Next Page
Loading...
