IMPxxx Series User Guide
IMPORTANT SAFETY INSTRUCTIONS
This product is connected to lethal voltages.
Observe all safety instructions.
This equipment is designed to comply with BSEN 61010-1 (Safety
requirements for electrical equipment for measurement, control, and
laboratory use) – observe the following precautions:
Ensure that the supply voltage agrees with the rating of the
equipment printed on the back panel before connecting the mains cord
to the supply.
This appliance must be earthed. Ensure that the instrument is
powered from a properly grounded supply outlet.
Keep the ventilation holes on the instrument free from obstruction.
Do not operate or store under conditions where condensation may
occur or where conducting debris may enter the case.
There are no user serviceable parts inside the instrument – do not
attempt to open the instrument, refer service to the manufacturer or
his appointed agent.
In the event of a failure, switch off the power source and ensure that
the output current has fallen to zero before connecting or disconnecting
any phase inputs.
Note: Newtons4th Ltd. shall not be liable for any consequential
damages, losses, costs or expenses arising from the use or misuse of
this product however caused.
IMPxxx Series User Guide
IMP161 Connection Diagram
To Next Page
Loading...
