Nabtesco RV E Series - Preparation of Required Components

To Next Page

To Previous Page

Chapter 4 Preparations for installation

4.2. Preparation of required components

 The following components and materials are required for installing this product. Check the

components/materials and prepare them at each customer’s site.

 If the shape of the actual section differs from the illustration below, refer to the separately provided

“Outer dimensions” drawings and specification sheet.

 Prepare the input gear, motor mounting flange, case installation component, and shaft installation

component that have been designed and manufactured based on the catalog and separately provided

“Outer dimensions” drawings and specification sheet.

Fig. 4-1 (E series)

Fig. 4-3 (Original series)

Fig. 4-2 (C series)