4. Insert the plug of the cable into a wall socket (see Safety Regulations).
Use as a Self-contained Machine
In this mode the machine washes and dries with the spray nozzle and the vacuum head, which is
situated below the body of the machine.
To switch on the machine you must act on the switches on the control panel:
1. Set to position "I" the switch of the vacuum motor.
2. Set to position "I" the pump switch. In this way the solution pump works only while you rotate
the hand grip of the machine.
3. To clean carpets, rotate the lever on the vacuum head towards the right side. To clean hard
floors, rotate it towards the left side.
4. To activate the rotating brush switch the power to “on”, the switch is located near the
vacuum head.
5
To Next Page
Loading...
