Nachi EZ-CFDL Series - 3.15 How to copy the soft-key settings between the controllers; 3.16 Operation condition

3.15How to copy the soft-key settings between the controllers
3.16
Operation
condition
3.16.1
Operation condition
Normally
, it is not
necessary to change the settings in this screen.
Setting procedure
1
Open <Constant Setting> - [5 Operation Constants] [1 Operation condition].
＋
2
Change the setting for the
respective items.
3
Press <Complete>.
>>The settings will be
saved in the
memory
.
T
able
3.16.1
Operation
condition
Item Description
Ground angle fixed
motion
This setting decides if the 3rd
axis will move when the 2nd
axis moves.
<Disabled>
The 3rd axis will not
move when the 2nd axis moves.
<Enabled>
The 3rd axis will move to
keep its angle against the
ground when the 2nd axis moves.
(NOTE) This is available in the system software FDV03.17 or after.
(NOTE) To change this setting, an operator class of
EXPERT
or higher is
required.
POINT
For other items, refer to the help function.