Nachi EZ-CFDL Series - Chapter 4 Home position registration; 4.1.1 Home position; 4.1.2 Home position registration by referencing the program; 4.1.3 Home position registration by manual recording

4.1 Home position registration
4.1.3
Home position registration by manual recording
This method is used to record the home position directly without referencing the program. Operate the robot
to set it.
The home position registration is not changed in tandem with any modifications made by teaching, and the
absolute position is now registered. Unlike the program reference system, a programs need not be provided
ahead of time.
Only the differences from the
program reference system will be
described below.
1
Set "Position" to "Manual."
>>The setting screen changes as shown below.
2
Turn on the motor power (servo power),
and move the robot by manual
operations to the position which is to serve as the home position.
Once the position has been
determined, release the enable switch.
(Alternatively, turn off the motor power.)
3
Press the <Current Record Posi.> f key.
>>The current position is read from the robot encoder, and the position data of each
axis is displayed in the
center.
4
Set the "TCP" in the same w
ay as with referencing the program. (The next steps
are the same.)