Need help?Do you have a question about the NAD 114 and is the answer not in the manual?
General| Input impedance (R and C) MM & RC | 47K + 200pF |
|---|---|
| Input sensitivity ref. 0.5V 1KHz MM | 1.5mV |
| Input sensitivity ref. 0.5V 1KHz MC | 1mV |
| Input overload 20Hz/1KHz/20KHz MM | 20mV/200mV/1700mV |
| Input overload 20Hz/1KHz/20KHz MC | 1.3mV/13mV/110mV |
| Signal to noise ratio (A-weighted with cartridge connected) MM | 76dB ref. 5mV |
| Signal to noise ratio (A-weighted with cartridge connected) MC | 76dB ref. 0.5mV |
| RIAA accuracy MM | ±0.2dB 20Hz - 20KHz |
| RIAA accuracy MC | ±0.2dB 50Hz - 20KHz |
| -0.5dB at | 20Hz |
| Impedance (R+C) | 20K + 450pF |
| Sensitivity ref. 0.5V | 80mV |
| Maximum input signal | >10V |
| Signal to noise A-weighted | 98dB ref. 0.5V |
| Frequency response (20 - 20kHz in tone defeat mode) | ±0.2dB |
| THD | 0.01% |
| Output impedance Pre-amp | 220 |
| Tape Source Z + | 2K |
| Phones | 120, >8V into 600 |
| Maximum output level Pre-amp | >12V |
| Tape | >10V |
| 250mV into | 8 |
| Treble | ±7dB at 10KHz |
| Bass | ±10dB at 50Hz |
| Dimensions (W x D x H) | 435 x 280 x 80mm |
| Weight | 3.7Kg |
| Shipping weight | 4.4Kg |
| Power consumption | 17W |
Warnings about risk of electric shock, not opening the unit, and handling damaged cords.
Instructions on unit placement, avoiding water, heat, and ensuring proper airflow for ventilation.
Guidelines on when to seek qualified service personnel and the risks of unauthorized repairs.
Guide for setting the switch based on cartridge output for optimal performance.
Output jacks for connecting to a power amplifier or signal processors.
Adjusts the relative level of low frequencies in the audio output.
Adjusts the overall loudness level of the sound output.
Addresses common no sound problems like power, connections, or fuse issues.
Guides on diagnosing and resolving issues with only one audio channel working.
To Next Page
