NAD CS1 - Google Home App with Ios Device; Google Home App with Android Device

ENGLISH
5
c Under SETUP NEW AIRPLAY SPEAKER, select your CS1 speaker
indicated by NAD-CS1xxxx where xxxx corresponds to the last 4
digits of the Machine Access Control (MAC) address of your CS1.
The complete MAC address can be found at the bottom section of
your CS1.
d When AirPlay Setup screen comes up, select Next. Note that you
can also customize the name of your CS1 by entering desired name
in the line item Speaker Name.
e Airplay Setup will proceed automatically. Follow or monitor screen
prompts until setup is completed. Select Done to exit setup mode.
2 GOOGLE HOME USING iOS DEVICE
a Open Google Home App using your iOS device.
b Select Set up NAD CS1 devices or similar.
c Choose a home where your NAD CS1 will be assigned and then
select Next.
d Nearby devices found will be shown. Choose or confirm the device
you would like to setup.
e Choose NAD-CS1xxxx where xxxx corresponds to the last 4 digits
of the Machine Access Control (MAC) address of your CS1. Select
Next.
f Select Yes if you heard the sound as your NAD CS1 gets connected.
Follow screen prompts.
g Choose a location for your NAD CS1 – this will help name your CS1.
You may also select Add a custom room name to enter preferred
name for your CS1. Select Next.
h Connect to Wi-Fi. Choose the Wi-Fi network you would like to use
with your CS1. Enter the Wi-Fi password.
i Follow or execute instructions on the screen prompts until Finish
Tutorial is selected. CS1 setup is now complete.
INTRODUCTION
QUICK SETUP GUIDE
3 GOOGLE HOME USING ANDROID DEVICE
a Open Google Home App using your Android device.
b Select + icon on the upper left corner of the App.
c Under Add to home, select Set up device.
d Select New device.
e Choose a home where your NAD CS1 will be assigned and then
select Next.
f Nearby devices found will be shown. Choose or confirm the
device you would like to setup.
g Choose NAD-CS1xxxx where xxxx corresponds to the last 4 digits
of the Machine Access Control (MAC) address of your CS1. Select
Next.
h Select Yes if you heard the sound as your NAD CS1 gets
connected. Follow screen prompts.
i Choose a location for your NAD CS1 – this will help name your CS1.
You may also select Add a custom room name to enter preferred
name for your CS1. Select Next.
j Connect to Wi-Fi. Choose the Wi-Fi network you would like to use
with your CS1. Enter the Wi-Fi password or use saved password for
the Wi-Fi network you selected.
k Follow or execute instructions on the screen prompts until xxx
Speaker is Ready is displayed and a Tutorial clip about Casting is
selected or skipped. CS1 setup is now complete.