NAD SR8 - ADDENDUM User Manual

The SR 8 can store a dierent library of default NAD codes for each of its DEVICE SELECTOR “pages.” If
the original default library does not control your NAD CD player, DVD player or other components,
follow the procedure below to change the library code. Refer as well to the table below for a list of
applicable NAD Library Codes with their corresponding NAD models.
LOAD ANOTHER LIBRARY CODE
Example: Load NAD DVD Player T 517 library codes to SR 8’s “CD” device.
1 Press and hold [CD] in the DEVICE SELECTOR section of SR 8.
2 While holding down the device button (CD), press “2” and “2” using SR 8’s numeric buttons. “22” is
the corresponding library code for T 517.
3 Press [ENTER] while still holding down the device button (CD). The CD device selector will ash
once to indicate that the library input is successful. Both the device selector button (CD) and
[ENTER] can now be released.
RESET THE SR 8 TO ITS DEFAULT SETTINGS
The SR 8 can be restored to its factory settings, including default libraries, by the following procedures
1 Press and hold [ON] and [DELETE/CLEAR] buttons for about 10 seconds until the AMP device
button lights up.
2 Within two seconds of the AMP device button lighting up, release both buttons. If the reset mode
is successful, the [CD] device button will ash twice.
TABLE OF LIBRARY CODES APPLICABLE TO SR 8 REMOTE CONTROL
LIBRARY CODE NAD PRODUCT DESCRIPTION
10 Default library for “AMP” page
11 Zone 2
20 Default library for “CD” page; C 515BEE, C 545BEE, C565BEE
21 T 535, T 585, M55, DVD section of L 54, VISO TWO, VISO FIVE
22 T 513, T 514, T 515, T 517
23 T 587
31 IPD 2
40
Default library for “TUN” page; Tuner section of C 725BEE, T 175, T 737, T 747, T 755, T 765,
T775, T 785
41 C 422, C 425
42 C 445
NOTE
The SR 8 may not necessarily contain all the control buttons applicable for the above-mentioned
NAD products. Use the prescribed remote control of the specic NAD product for a full compliment
of the applicable remote control buttons.
USING THE SR 8 REMOTE CONTROL LIBRARY
ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ

NAD SR8 - ADDENDUM Specifications

General

Brand	NAD
Model	SR8 - ADDENDUM
Category	Remote Control
Language	English

Summary

Load Another Library Code

Select Device

Press and hold the CD button in the DEVICE SELECTOR section to initiate device selection.

Enter Library Code

Enter the two-digit library code using numeric buttons while holding the device button.

Confirm Code Entry

Press ENTER to confirm. The device selector button will flash to indicate success.

Reset SR 8 to Default Settings

Initiate Reset

Press and hold ON and DELETE/CLEAR for 10 seconds until the AMP device button lights up.

Confirm Reset

Release buttons within two seconds of AMP light-up. A double flash of CD confirms reset.

NAD Library Codes Table

Library Code Reference

Table listing library codes applicable to the SR 8 remote control and their NAD product descriptions.

Important Note on Button Compatibility

The SR 8 may not have all buttons for every NAD product; use the product's specific remote for full functionality.