As NAD develops new features, we likewise update existing models with these new developments.
The new SR 8 remote control replaces the SR 6 remote control for the customer to enjoy additional
controls and functions applicable for a variety of NAD models.
USING THE SR 8 REMOTE CONTROL
The SR 8 remote control handset handles the key functions of the C 355BEE as well as other NAD
Stereo Receivers, Integrated Ampliers and Preampliers. It has additional controls to remotely operate
NAD CD Players, AM/FM Tuners and dedicated AM/FM/DAB Tuners. It will operate up to a distance of
23ft (7m). Alkaline batteries are recommended for maximum operating life. Two AA batteries should
be tted in the battery compartment at the rear of the Remote Control handset. When replacing
batteries, check that they have been put in the right way round, as indicated on the base of the battery
compartment.
When a command from the remote control is received, the Standby LED indicator will blink. Note that
the indicat
or may also blink when receiving commands not necessarily for the C 355BEE but for other
components in the system. Please refer to previous sections of the manual for a full description of
individual functions.
NOTE
The remote control handset supplied with the C 355BEE is of a universal NAD type, designed to
operate several NAD models. Some buttons are applicable only to specic NAD models. Contact
your dealer or NAD audio specialist for assistance.
1 POWER ON & OFF: The SR 8 remote has a separate ON and OFF button. Press the ON button
to switch the unit from Standby to operating mode. Press the OFF button to switch the unit to
Standby mode.
2
DEVICE SELECTOR: A Device Selector button determines only what component the SR 8 will
command; it does not perform any function on the C 355BEE. Press desired Device Selector button
for the applicable buttons to be directed to a “page” of commands relevant to the selected device.
Upon selec
ting a Device, you can now press the corresponding SR 8 control buttons applicable for
the selected Device.
3
INPUT SELECTORS: Refer to the corresponding labels printed in the remote control faceplate
and their respective assigned buttons to make use of these functions. Set the DEVICE SELECTOR
to “AMP” in order to gain access to these buttons. The input selector buttons perform the same
functions as the buttons labeled the same on the front panel.
4
NUMERIC KEYS: The numeric keys allow for direct input of tracks for CD players, and direct
channel/preset access for tuners and receivers.
5 SLEEP: Switch o specic NAD Receiver or Tuner models after a preset number of minutes.
6 MUTE: Press the [MUTE] button to temporarily switch OFF the sound to the speakers and
headphones. MUTE mode is indicated by the Standby LED indicator ashing for NAD Integrated
Ampliers or “Mute” shown in the VFD of NAD Receivers. Mute does not aect recordings made
using the TAPE output but will aect the signal going to the PRE OUT output. Press MUTE again to
restore sound.
7
DIM (for use with NAD Stereo Receiver, Tuner and CD Player): Reduce, turn o or restore VFD
brightness. Depending on the NAD model, the brightness of the front panel display will vary when
you toggle this button.
ADDENDUM SHEET FOR SR 8 REMOTE CONTROL
2
7
8
9
1
3, 4
6
5
10
ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ
To Next Page
Need help?
General
