Need help?Do you have a question about the Nady Audio MPM 4130 and is the answer not in the manual?
General| Brand | Nady Audio |
|---|---|
| Model | MPM 4130 |
| Category | Music Mixer |
| Language | English |
Crucial safety guidelines for operating electronic devices, covering water, stability, volume, ventilation, and power.
Examine packaging and contents for shipping damage. Notify dealer and shipper if damage is found.
Connect AC power, ensuring correct voltage selection (115V/230V) for your region.
Adjusts Low (80Hz) and High (12kHz) frequencies with +/-15dB boost/cut.
Manages channel level, digital delay send level, and the main delay effect parameters.
Mic/Line input jack and Tape In/Out RCA jacks for audio sources and recording.
Controls Tape In level and the overall Master output level for the main bus.
Turns the unit ON or OFF. Turn levels down before powering on.
Selects 115V or 230V to match your region's power supply. Crucial for avoiding damage.
IEC connector for AC power input with a fuse holder for protection. Check fuse if issues arise.
Two 1/4" jacks for connecting one or two 8-ohm speaker cabinets. Avoid loads below 4 ohms.
1/4" TRS insert point for external processing or connecting to an external power amp.
Contact Nady Service Department by phone or email for service within the U.S.
Contact your local NADY AUDIO distributor for international service.
Do not attempt self-service; it is dangerous and voids the warranty.
To Next Page
