13 14
Ensure both turntable chassis and equipment support are both level
and secure.
6.2 Arm installation
Bring the 5 pin end of the toneram interconnect up through the arm housing.
Connect the tonearm interconnect to the connector on the bottom of
the tonearm. Note the connector is loose – this is intentional to reduce
microphonic eects.
Add a few drops of bearing oil to the ceramic collar.
Gently tighten up the three screws using the 1.5mm hex driver just enough to
stop the arm pillar rotating in the pedestal top plate in use.
6.3 Platter installation
Take the sub platter and bearing housing and push together.
Place the tonearm in the collar and line up the arrows on the tape.
To Next Page
Loading...
