NAIM UnitiLite - Page 12

Page 12 of 15 26/03/2010
NaimUniti Troubleshooting Guide.doc
• Check charge setting is to ‘Always’ or ‘Auto’ in the ‘Setup > Inputs > iPod > Charge’
menu.
• If the NaimUniti iPod charge setting is set to ‘Auto’ the iPod will not charge when
the iPod input is selected.
7.2
7.27.2
7.2 The iPod sound
The iPod soundThe iPod sound
The iPod sound is distorted when connected to front panel 3.5mm input
is distorted when connected to front panel 3.5mm input is distorted when connected to front panel 3.5mm input
is distorted when connected to front panel 3.5mm input
socket
socketsocket
socket
• Check the iPod volume is not set too high.
• Ensure the iPod EQ setting is switched off.
7.3
7.37.3
7.3 The iPod doesn't work when connected to the USB input
The iPod doesn't work when connected to the USB input The iPod doesn't work when connected to the USB input
The iPod doesn't work when connected to the USB input
• This is normal. iPods should only be connected to the rear panel iPod socket using a
Naim n-Link cable or to the front panel 3.5mm audio input.
7.4
7.47.4
7.4 The message ‘Cannot read iPod’ is displayed
The message ‘Cannot read iPod’ is displayedThe message ‘Cannot read iPod’ is displayed
The message ‘Cannot read iPod’ is displayed
• The NaimUniti is unable to communicate to the connected iPod. Disconnect the
iPod and re-connect, if issue persists switch off the Uniti then reset the iPod. Then
reconnect the iPod.
8
88
8 USB Devices
USB DevicesUSB Devices
USB Devices
8.1
8.18.1
8.1 A USB Storage device is not recognized
A USB Storage device is not recognizedA USB Storage device is not recognized
A USB Storage device is not recognized
• The storage device (especially USB hard discs without separate power supplies)
draws more electrical current from the USB interface than is permitted by the USB
standard. Only use USB storage devices that conform to the USB standard or use
storage devices with their own power supply.
• The storage device is not formatted with an appropriate file system. The NaimUniti
accepts storage devices with FAT16 or FAT32 file systems. For large music archives,
we recommend to use a NAS device with a UPnP server.
8.2
8.28.2
8.2 It takes a long time before the memory stick contents are available
It takes a long time before the memory stick contents are availableIt takes a long time before the memory stick contents are available
It takes a long time before the memory stick contents are available
• Devices with a large amount of music will take longer to scan/initialise.
8.3
8.38.3
8.3 The me
The meThe me
The message ‘Source Err. Cannot Read USB’ is diplayed
ssage ‘Source Err. Cannot Read USB’ is diplayedssage ‘Source Err. Cannot Read USB’ is diplayed
ssage ‘Source Err. Cannot Read USB’ is diplayed
• The USB device may be encrypted (e.g. Sony MP3 players). Connect it to the front
panel analogue input using a 3.5mm jack cable.