NAiS GT30 - Chapter 5 GT10 Configuration Settings; 5.2 Entering Configuration Settings from GTWIN Screen Creation Tool; 5.3 Entering Configuration Settings from the GT10 Main Unit

Chapter 5
GT10 Configuration Settings
This chapter describes the configuration settings for the GT10, and how they should be
entered.
5.1 GT10 Configuration Settings 79........................
5.1.1 Two Types of GT10 Configuration Settings 79....
5.2 Entering Configuration Settings from GTWIN Screen
Creation Tool 80.....................................
5.2.1 Opening the GT Configuration Settings 80.......
5.2.2 GT Configuration Settings: “Basic Setup” 81.....
5.2.3 GT Configuration Settings: “Communication
Parameters” 83..............................
5.2.4 GT Configuration Settings: “Auto-Paging” 86....
5.2.5 GT Configuration Settings: “Startup Screen
Settings” 88.................................
5.2.6 GT Configuration Settings: “Setup” 90...........
5.2.7 GT Configuration Settings:
“Hold PLC Device” 93.........................
5.2.8 GT Configuration Settings:
“GT Internal Device Hold” 94...................
next page