Connecting and Communicating with the PLC
GT10/GT30
51
4.2 Connecting the FP0
CAUTION
Because loose wiring is used for connection to the FP0 COM. port, no
dedicated cable is available. The cable should be provided by the
customer. When purchasing a cable, the following precautions should
be observed:
•
Shielded wire with a size of AGW#28 to 16 (conductor cross-section
surface area: 0.08 mm
2
to 1.25 mm
2
) should be used for connections.
•
For wiring procedures, please refer to “Wiring the COM. Port” on
page 26.
To Next Page
Loading...