Nakayama PB5600 - User Manual

Questions and Answers

J
jreynoldsAug 19, 2025
Why my Nakayama PB5600 is not starting?
- T
  tmcgrathSep 12, 2025
  Your Nakayama Brush Cutter might not be starting due to several reasons: * Lack of fuel in the tank or an obstructed fuel filter. * Fuel quality issues such as dirty fuel, water contamination, or an improper fuel mixture. * Issues with the spark plug, including oily deposits, insulation damage, or an incorrect spark gap. * Problems with the high voltage wire or coil. * Issues related to the piston ring, spark plug, or leakage in the cylinder and crankcase. * Poor contact between the high voltage wire and spark plug, or a faulty stop switch.
W
Wayne BlackAug 29, 2025
How to fix a Nakayama Brush Cutter that won't start?
- R
  Richard CookAug 29, 2025
  To fix a Nakayama Brush Cutter that won't start: 1. Make sure that the fuel tank is filled with fuel and the fuel filter is clean. 2. If the fuel is dirty or contains water, replace it. If there is too much fuel in the cylinder, remove and dry the spark plug and ensure the fuel mixture ratio is correct. 3. Check the spark plug for oily deposits, damage, or incorrect gap. Clean, replace, or adjust as necessary. 4. Inspect the high voltage wire and coil for breaks or looseness; replace or tighten them. 5. Examine the piston ring, spark plug and conjoint surface of the cylinder and crank case for any issues; replace or eliminate them as needed. 6. Ensure the high voltage wire and spark plug have good contact, and check the stop switch for faults.
K
Kristen GutierrezNov 9, 2025
What to do if my Nakayama PB5600 Brush Cutter fails to start?
- B
  Bradley SchroederNov 9, 2025
  If your Nakayama Brush Cutter fails to start, there are several potential causes: * Check if there is fuel in the tank and ensure the fuel filter isn't obstructed. Add fuel or clean the filter as needed. * The fuel might be dirty or contain water. Replace the fuel in this case. Also, if there's too much fuel in the cylinder, remove the spark plug and dry it. Ensure proper fuel mixture ratio. * The spark plug could be fouled with oily deposits, have insulation damage, or an improper gap. Clean or replace the spark plug, and adjust the gap to 0.6-0.7mm. * Inspect for a breach or break in the high voltage wire or looseness of the coil. Replace or tighten the wire, and tighten the coil. * Check the piston ring, spark plug and conjoint surface of the cylinder and crank case for attri...