nalanda MD030 - Specification; Assembly

3
the location of the buried metal, to help you to excavate.

Ground balance
Ground Balancing is the ability of the detector to ignore, or "see through," the
earth’s naturally occurring minerals, and only sound a tone when a metal object is
detected.

Coins depth
The coin depth is the approximate distance that the 25
￠
silver coin in the neutral
soil or in the air. It’s not an exact depth.
SPECIFICATION
 Operation mode: 1
＋
1
Motion mode: ALL-METAL
Non-motion mode: PINPOINT
 Coins depth indication: 1, 2, 3 Steps (2″,4″ and 6″+)
 Sensitivity control: 3 Steps
 Target metals discrimination: 3 kinds
 Sound frequency: Three kinds of sound indicating different metals
 Battery indication: Low battery indicate
 Turn off prompt: make a prompt tone every ten minutes
 Search coil: 210x70mm open waterproof search coil
 Earphone jack: 1/8 inch earphone jack(Earphone is not included)
 Power supply: 6 AA batteries (Battery is not included)
ASSEMBLY
1. Loosen the two triangular fasten buttons below the control box, insert the bracket,
then tighten the two triangular fasten buttons (See Fig.1).