Page 73
7-16 Replacing the Launcher Sensor
1. Remove the upper rear maintenance door from the Target Cabinet.
2. Disconnect the connector (CN26).
3. Remove 2off pozi flange head screws (M4x6) and remove the Launch Sensor
complete with Sensor Bracket.
4. Remove 1off pozi head screw (M4x12) and remove the Launch Sensor from the
Sensor Bracket.
5. Reassemble in reverse order.
Note: It is recommended that loctite 242 is applied to the pozi head screw (M4x12)
when reassembling.
Connector
(CN26)
Sensor Bracket
Pozi flange screw
(M4x6)
Pozi head screw
(M4x12)
Launcher Sensor
Sensor Bracket
To Next Page
Loading...
