Page 80
7-20 Replacing the Flat Target Drive Cable
1. Remove the upper rear maintenance door from the Target Cabinet.
2. Remove 2off flange socket screws (M4x6) and remove the Flat Target Drive
Cable.
3. Reassemble in reverse order.
Note: When refitting the Flat Target Drive Cable ensure that the cable is wound round
the motor pulley twice in a counter-clockwise direction as viewed in the
direction of the arrow shown in the diagram below.
Flange Socket Screw
(M4x6)
Flat Target
Drive Cable
Wire Bracket
Pulley
Wind the drive cable
counterclockwise twice
(as seen from the direction
of the arrow) around the
pulley before fixing
to the wire bracket.
Flat Target Motor
Flat Target
Drive Cable
To Next Page
Loading...
