Page 84
7-23 Replacing the Flat Target Position Detection Sensor
1. Remove the upper rear maintenance door from the Target Cabinet.
2. Disconnect connector (CN48)
3. Remove 1off pozi head screw (M4x12) and remove the Flat Target Position
Detection Sensor
4. Reassemble in reverse order.
Note: It is recommended that ThreeBond 1401 screw lock, (part No 95000006), is
applied to the pozi head screw (M4x12) when refitting the Flat Target Position
Detection Sensor.
Flat Target
Positition Detection
Sensor
Connector
(CN48)
Flat Target
Solenoid
Pozi head screw
(M4x12)
To Next Page
Loading...
