NAMCO Quick & Crash - Replacing the Flat Target Sensor Assy

Page 85
Flat Target
Sensor Assy
Target Plate
Pozi flange screw
(M4x6)
Flange Socket Screw
(M4x10)
Flange Socket Screw
(M4x12)
Connectors
(CN50)
Flat Target
Sensor Assy
7-24 Replacing the Flat Target Sensor Assy
1.Remove the Flat Target Assembly. (See Section 7-18 page 77).
2. Remove 2off pozi head screws (M4x6) and remove the Target Plate.
3. Disconnect the connector (CN50).
4. Remove 2off flange socket screw (M4x12), 1off flange socket screw (M4x10) and
remove the Flat Target Sensor Assy.
5. Reassemble in reverse order.