NAMCO Quick & Crash - Replacing the Flat Target Origin Sensor

Page 86
7-25 Replacing the Flat Target Origin Sensor
1. Remove the upper rear maintenance door from the Target Cabinet.
2. Disconnect connector (CN24).
3. Remove 1off pozi head screw (M4x12) with flat washer (M4) and remove the Flat
Target Detection Sensor.
4. Reassemble in reverse order.
Note: It is recommended that ThreeBond 1401 screw lock, (part No 95000006), is
applied to the pozi head screw (M4x12) when refitting the Flat Target Origin
Sensor.
Flat Target Origin
Detection Sensor
Connector
(CN24)
Flat Washer (M4)
Pozi head screw
(M4x12)
Flat Target Motor