NAMCO Quick & Crash - Replacing the Gun Detection Sensor

Page 87
7-26 Replacing the Gun Detection Sensor
1. Remove 1off security screw (M5x20), 1off security screw (M5x10) and remove
the Holder Cover.
2. Remove 2off pozi head screws (M4x20) and remove the Holder Bracket (C).
3. Remove 2off pozi head screws (M4x25), with flat and spring washers, and
remove the Holder Bracket (R).
Holder Cover
Security Screw
(M5x20)
Instruction
Panel
Holder Bracket (C)Gun Detection Sensor
(receiving side)
Holder Bracket (L)
Gun Detection Sensor
(projection side)
Holder Bracket (R)
Security Screw
(M5x10)
Front
Holder Bracket (L)
Pozi Head Screw
(M4x25)
Holder Bracket (R)
Front