NAMCO Quick & Crash - Replacing the Holder Cushions (A) (B) (C)

Page 92
7-29 Replacing the Holder Cushions (A) (B) (C)
1.Remove the Holder Cover and Holder Bracket (C). (See section 7-26 page 87)
2. The Holder Cushions (A) (B) (C) are attached using double-sided adhesive tape.
Pull firmly on the cushion and peel it from the holder bracket.
3. Apply the new Holder Cushion in reverse procedure.
Note: The Holder Cushions are supplied with double-sided adhesive tape fitted. Peel
off the backing paper before attaching the Holder Cushion.
Attach the holder cushion (A) (B) or (C) in the position shown in the diagram
below.
Holder Cushion (A)
Holder Cushion (C)
Holder Cushion (B)
Holder Bracket (C)
9
15
7
Holder Bracket (C)
Holder Cushion (C)
Holder Cushion (B)
Holder Cushion (A)
units = mm