Page 93
7-30 Replacing the Xenon PC Board
Note: PC Boards are susceptible to damage from static electricity. Anti static precautions
should be taken when removing, handling and refitting the PC Board.
1. Remove 2off Button head screws (M5x35) and remove the front maintenance
door from the Gun Cabinet.
2. Remove 2off pozi head screws (M4x12) and remove the Cover in the direction of
the arrow, as shown in the diagram below.
Button head Screw
(M5x35)
Front
Maintenance Door
Front
Cover
Pozi head Screw
(M4x12)
Xenon Assy
CAUTION
The Xenon Assy remains hot and continues to carry a high voltage charge even after
turning the power OFF. Wait at least five minutes after turning the power OFF before
performing any maintenance work (troubleshooting, repairs etc.) on the Xenon Assy.
To Next Page
Loading...
