Page 97
7-32 Removing the Xenon Fan and Filter
1. Remove 2off pozi head screws (M4x12) and remove the Filter Bracket.
2. Remove the Filter from inside the Filter Bracket.
3. Disconnect connector (CN37), remove 4off pozi head screws (M4x45), with
spring and toothed lock washers, and remove the Xenon Fan
4. Reassemble in reverse order.
CAUTION
The Xenon Assy remains hot and continues to carry a high voltage charge even after
turning the power OFF. Wait at least five minutes after turning the power OFF before
performing any maintenance work (troubleshooting, repairs etc.) on the Xenon Assy.
Xenon Assy
Filter
Filter Bracket
Pozi head screw
(M4x12)
Xenon Assy
Connector
(CN37)
Xenon Fan
Finger Guard
Pozi head screw
(M4x45)
(with spring and
toothed lock washer)
To Next Page
Loading...
