Page 98
7-33 Replacing the Gun Assy
Note: When removing the Gun Assy from the top cover on the Gun Cabinet, take care
not to bend, pull or scratch the harness or fibre optic cable.
1.Remove the Fibre Optic Cable. (See section 7-30 page 93)
2. Remove 4off Security screw (M5x10) that retains the Pipe Bracket, and pull the
Gun Assy out from the Gun Cabinet.
3. Disconnect connector (CN38) and remove the Gun Assy.
4. Reassemble in reverse order.
Note: Install the Top Cover so that the L shaped bracket on the rear of the Pipe
Bracket is at the top.
Top Cover
(gun cabinet assy)
Security Screw
(M5x10)
Gun Assy
Pipe Bracket
Fibre Optic Cable
Top Cover
(gun cabinet )
Connector
(CN38)
Pipe Bracket
Gun Assy
Pipe Bracket
Details of the Pipe Bracket
To Next Page
Loading...
