EasyManuals Logo

Nanni N2.10 User Manual

Nanni N2.10
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #28 background imageLoading...
Page #28 background image
Before starting
I WARNING
Put all the protective covers back
before starting the engine.
I CAUTION
Open the sea cock (if equipped)
before starting the engine. The
raw water pump impeller will be
damaged if it runs dry even for
few seconds, and may lead to
engine overheating.
Perform all of the following opera-
tions before starting the engine:
1. Open sea cock (if fitted). Prime
the raw water system if neces-
sary.
2. Start the compartment fan (if
fitted) for at least five minutes.
Otherwise, open the hold.
3. Check that there is sufficient
fuel.
4. Move the control lever to the
neutral position.
5. Open fuel cock, prime the sys-
tem if necessary.
6. Check the engine and trans-
mission oil level and fill with the
recommended oil if necessary.
7. Check the coolant level, top up
if necessary.
8. Check the control cables,
grease the connections if neces-
sary.
9. Check there are no fuel, oil,
coolant or water leaks.
10. Check the alternator belt.
11. Switch ON the main switches.
25
OPERATION
6

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nanni N2.10 and is the answer not in the manual?

Nanni N2.10 Specifications

General IconGeneral
BrandNanni
ModelN2.10
CategoryEngine
LanguageEnglish

Related product manuals