Nanni N4.140 - Page 44

44
S07 START & RUNNING
ENGINE START
Type 4 panel with key:
1. Move the control lever to the neutral position.
ASTERN
NEUTRAL
AHEAD
2. Insert the key in the ON/STOP starter switch.
3. Turn the key a quarter-turn to the right (on C4 and
A4 panel). All the warning lamps come on and the
acoustic alarm sounds. After a few seconds, only the
engine oil pressure and Battery charge lamps do lit.
NOTE !
On Eco 4 Panel, only the oil pressure and battery charge
lamp light on.
BEEP
START
STOP
STARTING
4. Press the Start button halfway (position 1/2) to start
preheating. Hold the button for 10 to 20 seconds,
depending on ambient temperature to preheat the
engine.
POSITION 1
POSITION 1/2 : preheating
POSITION 2
5. Press fully to start the engine (position 2). Once the
engine has started, release the button, all lamps go
out.
POSITION 1
POSITION 1/2
POSITION 2 : start
6. If the engine is fit with water cooled exhaust elbow,
check that water flows from the exhaust outlet at the
hull. If the water does not flow, stop the engine and
check the raw water system.