45
S07 START & RUNNING
Type 4 panel without key:
1. Switch the key of the main panel to ignition (if
equipped).
2. Move the control lever to the neutral position.
ASTERN
NEUTRAL
AHEAD
3. Press the ON/STOP button. All the warning lamps
come on and the alarm sounds (on C4 and A4 panel).
After a few seconds, only the engine oil pressure and
Battery charge lamps remain lit.
NOTE !
On Eco 4 Panel, only the oil pressure and battery charge
lamp light on.
4. Press the Start button halfway (position 1/2) to start
preheating. Hold the button for 10 to 20 seconds,
depending on ambient temperature to preheat the
engine.
POSITION 1
POSITION 1/2 : preheating
POSITION 2
5. Press fully (position 2) to start the engine. Once the
engine has started, release the button, all lamps go
out.
POSITION 1
POSITION 1/2
POSITION 2 : start
6. If the engine is fit with water cooled exhaust elbow,
check that raw water flows from the exhaust outlet
at the hull. If the water does not flow, stop the engine
and check the raw water level.
To Next Page
Loading...
