Inspection and adjustment of the levels
Fuel fi lter
I Attention ! : Always sponge up any fuel which may
have spilled Observe the environment protection rules.
A. Fuel fi lter cartridge
The fuel fi lter is a throw-away type fi lter. The fi reguard envelope
and the water probe must be preserved and reinstalled
correctly (if equipped). The fi re guard must not come into
contact with the plastic purge screw.
• Close the fuel valve
• Unscrew the cartridge from the fi lter head
• Coat the seal of the new cartridge with clean oil
• Screw the new cartridge on the fi lter head, then tighten by
hand by ¾ turn (do not use a tool).
• Reinstall the probe and the purge screw (if equipped).
Check the seal
• Open the fuel valve
• Purge the circuit
• Start up the engine and check for any leaks
Zinc anode
I Warning !: Perform this operation with the engine
stopped and cold.
A zinc anode forms part of the exhaust elbow . It serves as
an anticorrosion anode. The anode must be replaced when
more than 50% of it has been consumed.
Diameter : 10 mm
Length : 16 mm
A
To Next Page
Loading...
