3
4
Grasp thin tube bend at the entrance of the ear canal.
Gently pull thin tube out of ear, removing dome from ear.
Remove hearing aid from behind the ear.
Wipe dome clean from any wax, oils, moisture, etc.
Power aid off. Place aid in charging case when not in use.
Hold the thin tube bend with your thumb and finger as
shown. Gently insert the dome into your ear canal.
Using your finger, position the stabilizer into the curvature
of your ear. The stabilizer helps keep the aid secure in your ear.
STEP THREE
Make Adjustments to Your
Hearing Aid Using the Upper
and Lower Button
STEP FOUR
Remove Hearing Aid
Tip: To avoid feedback/chirping when aid is being
removed, turn aid off prior to removal.
Place hearing aid behind your ear.
Turn hearing aid on.
If hearing aid is off, press and hold the lower button for 3 seconds
until the hearing aid turns on.
STEP TWO, CONT... STEP TWO, CONT...
seconds
Quick Press
VOLUME INCREASE
UPPER BUTTON
Press & Hold
TURN ON & OFF
Quick Press
VOLUME DECREASE
LOWER BUTTON
Press & Hold
CHANGE PROGRAM
seconds
To Previous Page
Loading...
