Technical manual
SMCI33 V2.0
Editorial
2 Issue: V 2.0 - 2009-07-01
Editorial/About this manual
© 2009
Nanotec
®
Electronic GmbH & Co. KG
Gewerbestraße 11
D-85652 Landsham / Pliening, Germany
Tel.: +49 (0)89-900 686-0
Fax: +49 (0)89-900 686-50
Internet: www.nanotec.com
All rights reserved!
MS-Windows 2000/XP/Vista are registered trademarks of Microsoft Corporation.
Thank you for choosing a Nanotec stepper driver!
Target group
This technical manual is aimed at designers and developers who need to operate a
Nanotec
®
stepper motor without much experience in stepper motor technology.
About this manual
This technical manual must be carefully read before installation and commissioning
of the driver.
NanotecNanotec
®
reserves the right to make technical alterations and further
develop hardware and software in the interests of its customers to improve the
function of this product without prior notice.
This manual has been written with due care. It is exclusively intended as a
technical description of the product and as commissioning instructions. The
warranty is exclusively for repair or replacement of defective equipment, according
to our general terms and conditions, liability for subsequent damage or errors is
excluded. Applicable standards and regulations must be complied with during
installation of the device.
For criticisms, proposals and suggestions for improvement, please contact the
above address or send an email to: info@nanotec.com
Version/Change overview
Version Date Changes
1.0 2009-02-20 New issue C+P
2.0 2009-07-01 Revision C+P
To Next Page
Loading...
Need help?
General
