What to do if there is a transmission fault in NANOTEC SMCI36 Controller?
A transmission fault with the NANOTEC Controller may occur if data transmission to the SMCI36 is disturbed. To resolve this, check that the motor connection is correctly wired. It is recommended to use the Nanotec converter ZK-RS485-USB.
Why does NANOTEC SMCI36 Controller show a position error?
A position error in the NANOTEC Controller occurs if the motor cannot reach the desired position or if the limit switch has been overrun. To resolve this, click the button in the error message to reset the error.
How to fix NANOTEC SMCI36 if it is not ready?
If the NANOTEC Controller is not ready, it might be due to several reasons. It could be a communication error because of a wrong COM port selection. In this case, select the correct PC port in the tab to which you connected the SMCI36. Also, check the baud rate setting and ensure it is set to 115200 bps in the tab. Verify the communication cable is correctly connected, using only the recommended ZK- RS485-USB converter from Nanotec. Another reason may be a non-existent module number. Set the correct module address. Check that the power supply of the SMCI36 is not interrupted, and switch it on if necessary. Also, close any other programs on your PC that might be blocking the COM port. Finally, if inadmissible data was sent during a travel profile output, click the button to stop the prof...
General| Brand | NANOTEC |
|---|---|
| Model | SMCI36 |
| Category | Controller |
| Language | English |
To Next Page
