Napa 791-2300 B - User Manual

791-2300 B, 791-2320 B 1 rev. 03/12/18
SPECIFICATIONS
791-2300 B 791-2320 B
Capacity ........................................12 Ton ...................... 20 Ton
Minimum Height .......................... 10-1/4" .....................10-3/8"
Ram Travel .................................... 6-3/4" .......................6-1/4"
Screw Extension ........................... 3-1/8" .......................3-1/4"
Maximum Height ......................... 20-1/8" .....................19-7/8"
Air Pressure ........................... 110 to 120 PSI .........110 to 120 PSI
Shipping Weight ......................... 28.2 lbs. ....................34.7 lbs.
MODEL # 791-2300 B, 791-2320 B
12 & 20 TON CAPACITY
AIR BOTTLE JACK
BEFORE USING THIS DEVICE, READ THIS
MANUAL COMPLETELY AND THOROUGHLY,
UNDERSTAND ITS OPERATING
PROCEDURES, SAFETY WARNINGS AND
MAINTENANCE REQUIREMENTS.
It is the responsibility of the device owner to make sure all personnel
read this manual prior to using the device. It is also the responsibility
of the device owner to keep this manual intact and in a convenient
location for all to see and read. If the manual or product labels are lost
or not legible, contact NAPA for replacements. If the operator is not
fluent in English, the product and safety instructions shall be read to
and discussed with the operator in the operator's native language by
the purchaser/owner or his designee, making sure that the operator
comprehends its contents.
WARNING
WARNING: This product can expose you to chemicals
including nickel, which is known to the State of
California to cause cancer and birth defects or other
reproductive harm. For more information go to www.
P65Warnings.ca.gov.
S
A
F
E
T
Y
S
T
A
N
D
A
R
D
C
O
M
P
L
I
E
S
I
T
H
W
ASME PASE-2014
• Read, study, understand & follow all instructions before us-
ing. • Inspect the jack before each use. Do not use if damaged,
altered, modied, in poor condition, leaking hydraulic uid or un-
stable due to loose or missing components. Make corrections
before using. • Lift only at points of the vehicle as specied by
the vehicle manufacturer. • User and bystanders must wear eye
protection that meets ANSI Z87.1 and OSHA standards. • Do
not exceed rated capacity. • No persons should be under vehicle
when jack is in use. • This is a lifting device only. Immediately
after lifting, support the vehicle with appropriate means.
• No alterations shall be made to this product. • Use only on a
hard level surface. • Always lower the jack slowly and carefully.
• Do not use saddle adaptors or saddle extenders between the
stock lifting saddle and the load. • Center load on saddle. Be
sure setup is stable before working on vehicle. • Failure to heed
these warnings may result in serious or fatal personal injury and/
or property damage.

Summary

Product Overview and Initial Safety

Operating Instructions Prior to Use

Read and thoroughly understand the manual before operating this device.

Critical Safety Warnings

Essential warnings to prevent injury or death, including eye protection and load capacity.

Technical Specifications

Details on capacity, dimensions, and air pressure requirements for the jack.

Hazard Identification and Prevention

Understanding Hazardous Situations

Explains inherent hazards and the need for intelligence, care, and common sense.

Methods to Avoid Hazards

Steps to prevent accidents, including proper inspection, usage, and vehicle support.

Consequences of Hazardous Situations

Details potential serious or fatal injuries and property damage from non-compliance.

Assembly and Operation

Assembly and Setup Instructions

Guidance on assembling the handle and preparing the jack for use.

Purging Air from Hydraulic System

Procedure to remove trapped air from the hydraulic system for proper function.

Operating the Air Bottle Jack

Step-by-step guide on activating, lifting, lowering, and supporting loads safely.

Maintenance, Troubleshooting, and Responsibility

Preventative Maintenance

Key steps to prevent jack failure, focusing on air system cleanliness and lubrication.

Maintenance and Fluid Requirements

Guidelines for using correct hydraulic oil and adding fluid.

Owner;User Responsibility

Defines the user's role in understanding, following, and maintaining instructions.

Troubleshooting Common Issues

Identifies symptoms, causes, and corrective actions for jack malfunctions.

Parts Breakdown and Identification

791-2300 B Parts List

Detailed list of parts for the 12 Ton Air Bottle Jack.

791-2320 B Parts List

Detailed list of parts for the 20 Ton Air Bottle Jack.

Parts Identification Diagrams

Visual exploded views of the jack components for easy identification.

Napa 791-2300 B Specifications

General

Brand	Napa
Model	791-2300 B
Category	Jacks
Language	English