Napa CARLYLE DTW12FL User Manual

DTW38FL, DTW12FL 1 Rev. 01/23/13
DTW39FL, DTW12FL
3/8" Torque Range .....................................5.0-99.5 ft.-lbs.
1/2" Torque Range ...................................12.5-250.0 ft.-lbs.
Torque Accuracy (*1) ............................ (CW ±2%) (CCW ±3%)
Angle Accuracy (*2) ............... +/- 2° ( rotating 90° at speed of 30°/sec)
Angle Range.................................................1˚-360˚
Data Memory Values ............................................ 50
Number of Presets ................................................ 9
Operation Modes .....................................Peak Hold/Track
Unit Selection..........................N-m, in-lb, ft-lb, kg-cm & Degrees
Head Type .............................................Flex Ratchet
Gear teeth ..................................................... 36
Audible Alarm...................................................Yes
Buttons......................................................... 5
LED Indicator ..............................................12 LED's
Batteries ......................................................2 AA
Battery Life-Continuous Operation (*3) ............................60 Hrs
Battery Life-Standby (*3) ....................................... 1 Year
Operating Temperature ...................................14ºF ~ 140ºF
Storage Temperature .....................................-4ºF ~ 158ºF
Humidity ...................................Up to 90% non-condensing
ALWAYS READ
INSTRUCTIONS
BEFORE USING
TOOLS
ALWAYS WEAR
SAFETY
GOGGLES
NOT
WATERPROOF
DTW38FL, DTW12FL
3/8" and 1/2" Digital Torque Wrenches with Angle Indicator
WARNING
SPECIFICATIONS

Napa CARLYLE DTW12FL Specifications

General

Brand	Napa
Model	CARLYLE DTW12FL
Category	Power Tool
Language	English

Summary

Specifications

General Safety Warnings

Battery Installation and Setup

Battery Installation

Instructions for installing two AA batteries into the torque wrench compartment.

Power On and Resetting

Procedure to power on the digital torque wrench and how to reset the unit.

Operating Modes

Selecting Units of Measure

Setting and Resetting Torque Values

Setting Torque Values

Instructions for increasing or decreasing torque values using the Up/Down arrows.

Resetting Preset Torque Values

Procedure to change or store preset torque values in memory.

Track and Peak Modes

Selecting Track and Peak Modes

Track Mode Operation

Peak Hold Mode Details

Storing Peak Hold Values

Viewing Peak Hold Values

Managing Peak Hold Values

Using the Angle Function

Setting Angle Values

Resetting Preset Angle Values

Angle Mode Operation

Angle Value Management

Storing Angle Values

Troubleshooting Error Codes

Error Codes for Angle Feature

Explanation of error codes (E-0, E-4, E-5, Err) and their corrective actions.