Narada 48NPFC20 - User Manual

Questions and Answers

T
Tiffany ColeAug 9, 2025
What to do if Narada Camera Accessories battery cannot discharge?
- C
  coxmarcAug 9, 2025
  If your Narada Camera Accessories battery isn't discharging, it could be due to several reasons. It might be protected against under-voltage, in which case you should charge the battery. It could also be due to over-temperature or under-temperature; ensure the cell temperature is between -20°C and 70°C for discharge. A short circuit could be the cause; relieve the short circuit and charge the battery. Alternatively, it might be drawing too much current; remove some unimportant load and charge the battery. If none of these resolve the issue, it could be a system failure, in which case you should shut down the system and call maintenance service.
P
Pamela LongAug 16, 2025
What to do if Narada Camera Accessories battery cannot charge?
- D
  deborah23Aug 16, 2025
  If your Narada Camera Accessories battery is not charging, there could be a few reasons. It might already be fully charged, which is normal. Another reason might be protection against over voltage, which doesn't require any action. If the cell temperature is too low (lower than -10°C) or too high (higher than 70°C), regulate the cell temperature between 0°C and 55°C for charging. If none of these seem to be the issue, there may be a system failure, requiring you to shut down the system and contact maintenance service.
P
Pamela JohnsonAug 25, 2025
Why all LED indicators on Narada Camera Accessories are on?
- D
  deborahhardinAug 25, 2025
  If all the LED indicators on your Narada Camera Accessories are on, this indicates a system failure. In this case, you should shut down the system and call for maintenance service.
J
John WilliamsSep 1, 2025
How to fix communication failure in Narada Camera Accessories?
- E
  Elaine TaylorSep 1, 2025
  If you are experiencing a communication failure with your Narada Camera Accessories, there are a few things you can check. First, inspect the communication cable for any faults. If the cable is fine, try pressing the RESET button in case there's a halt in system communication management. If the problem persists, it could be a system failure, requiring you to shut down the system and call for maintenance service.