Need help?Do you have a question about the Nastec Vasco V406 and is the answer not in the manual?
Provides measures to ensure electromagnetic compatibility (EMC) of the system.
Recommends adjustments for long motor cables to reduce commutation frequency and prevent voltage spikes.
Details recommended parameters for circulation systems, including control and IN/OUT parameters.
Explains the initial setting menu for configuring pump characteristics, sensor range, and system characteristics.
Details default and description for various operational parameters like language, units, motor type, and control modes.
Outlines the steps for performing auto-tuning to calibrate FOC control, including wiring and initial configuration.
Discusses adjusting FOC control dynamics based on configuration to ensure stable operation and prevent alarms.
Details motor overload, under voltage, and over voltage alarms, including descriptions and solutions.
Covers inverter over-temperature and no-load alarms, their causes, and recommended solutions.
Addresses dry run (low cosphi) and sensor fault alarms, providing troubleshooting steps and protective actions.
Details alarms for maximum/minimum value limits and IGBT trips, suggesting parameter adjustments and checks.
Covers communication errors, address conflicts, and keyboard faults, with troubleshooting advice.
Relates to digital input status alarms and slave errors detected by the master, requiring parameter checks.
Provides steps to troubleshoot when the LCD does not switch on or the power line is interrupted.
Addresses sensor faults, control oscillations, and DOL pump stop/start issues with troubleshooting steps.
General| Brand | Nastec |
|---|---|
| Model | Vasco V406 |
| Category | Controller |
| Language | English |
To Next Page
