2 | ni.com | NI PXIe-5653 Calibration Procedure
Software
Calibrating the NI 5653 requires you to install one of the following packages on the calibration
system.
• NI-RFSA 2.4 or later
• NI-RFSG 1.7 or later
Note NI-RFSG automatically installs when you install NI-RFSA.
You can download all required software from
ni.com/downloads.
The software supports programming the calibration procedures in the LabVIEW, C, and
LabWindows
™
/CVI
™
application development environments (ADE). When you install the
software, you need to install support only for the ADE that you intend to use.
Documentation
You might find the following documents helpful as you perform the calibration procedure:
• NI 5665 RF Vector Signal Analyzer Getting Started Guide
• NI RF Signal Generators Help
• NI PXIe-5665 Specifications
The latest versions of these documents are available on
ni.com/manuals.
Test Equipment
Table 1 lists the equipment NI recommends for the performance verification and adjustment
procedures. If the recommended equipment is not available, select a substitute using the
minimum requirements listed in the table.
To Next Page
Loading...