National Instruments PCI-7811 User Manual

Chapter 1 Introduction
© National Instruments Corporation 1-9 R Series Multifunction RIO User Manual
Custom Cabling
NI offers a variety of cables for connecting signals to the NI 78xxR. If you
need to develop a cu stom cable, a nonterminated shielded cable is available
from NI. The SHC68-NT-S connects to the NI 78xxR VHDCI connectors
on one end of the cable. The other end of the cable is not terminated. This
cable ships with a wire list identifying the wires that correspond to each
NI 78xxR pin. You can use this cable to quickly connect the NI 78xxR
signals that you need to the connector of your choice. Refer to Appendix A,
Connecting I/O Signals, for the NI 78xxR connector pinouts.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

National Instruments PCI-7811 Specifications

General

Form Factor	PCI
Bus Interface	PCI
Digital I/O Lines	96
Maximum Digital I/O Update Rate	1 MHz
Analog Input Channels	0
Analog Output Channels	0
Number of DMA Channels	4
Operating Temperature	0 °C to 55 °C
Operating System Support	Windows, Linux
Digital I/O Logic Levels	TTL/CMOS compatible
Compatibility	NI R Series