© National Instruments | 2-25
RMC-8356 User Manual
Intel I210 Gigabit Network Connection -
00:25:90:5D:39:AF
NIC Configuration
Link Speed
Use this feature to specify the port speed used for the selected boot protocol. The options are
Auto Negotiated, 10 Mbps Half, 10 Mbps Full, 100 Mbps Half, and 100 Mbps Full.
Wake On LAN
Select Enabled for Wake_On_LAN support, which will allow the system to wake up when
an onboard LAN device receives an incoming signal. The options are Disabled and Enabled.
Blink LEDs
Use this feature to identify the physical network port by blinking the associated LED. Use the
keyboard to select a value.
UEFI Driver
This item displays the UEFI driver version.
Adapter PBA
This item displays the Processor Bus Adapter (PBA) model number. The PBA number is a
nine digit number (i.e., 010B00-000) located near the serial number.
Device Name
This item displays the adapter device name.
Chip Type
This item displays the network adapter chipset name.
PCI Device ID
This item displays the device ID number.
PCI Address
This item displays the PCI address for this computer. PCI addresses are 3 two-digit
hexadecimal numbers.
Link Status
This item displays the connection status.
MAC Address
This item displays the MAC address for this computer. Mac addresses are 6 two-digit
hexadecimal numbers.
To Next Page
Loading...
Need help?
General
