National Instruments cRIO-9039 User Manual

GETTING STARTED GUIDE
NI cRIO-9039
Embedded CompactRIO Controller with Real-Time Processor and
Reconfigurable FPGA
This document describes how to begin using the NI cRIO-9039 and NI cRIO-9039 Sync.
In this document, the NI cRIO-9039 and NI cRIO-9039 Sync are inclusively referred to as the
cRIO-9039.
For more information about timing and synchronization capabilities of NI cRIO-9039 Sync,
visit ni.com/info and enter the Info Code cRIO9039sync.

National Instruments cRIO-9039 Specifications

General

Processor	Intel Atom E3845
Processor Speed	1.91 GHz
Number of Cores	4
Operating System	NI Linux Real-Time
Nonvolatile Storage	8 GB
Chassis Slots	8
Chassis Type	CompactRIO
Ethernet Ports	2
Serial Port	1
USB Ports	2 x USB 2.0 Hi-Speed ports
Operating Temperature	-40 °C to 70 °C
Power Supply	9 VDC to 30 VDC

Summary

Safety Guidelines

Safety Guidelines for Hazardous Locations

Provides essential safety instructions for operating the cRIO-9039 in potentially explosive hazardous locations.

Special Conditions for Hazardous Locations Use in Europe and Internationally

Electromagnetic Compatibility Guidelines

Details EMC requirements and practices to ensure proper operation and minimize interference in industrial environments.

Preparing the Environment

Special Conditions for Marine Applications

Addresses specific EMC requirements and precautions for using the cRIO-9039 in marine (shipboard) applications.

Unpacking the Kit

Verifying the Kit Contents

Guides users on checking if all components are included in the cRIO-9039 kit upon arrival.

Installing Software on the Host Computer

Outlines the initial software and device driver installation steps required on the host computer.

Installing C Series Modules

Connecting the cRIO-9039

Installing C Series Modules

Step-by-step procedure for physically inserting and securing C Series modules into the cRIO-9039 slots.

Removing C Series Modules

Instructions for safely detaching and removing C Series modules from the cRIO-9039.

Connecting the cRIO-9039 to Ground

Details the procedure for properly grounding the cRIO-9039 unit to ensure electrical safety and performance.

Connecting the cRIO-9039 to Power

Powering On the cRIO-9039

Connecting the cRIO-9039 to the Host Computer

Guides on establishing a USB connection between the cRIO-9039 and the host computer for initial setup.

Configuring the System in Measurement & Automation Explorer (MAX)

Setting a System Password

Provides steps to configure a system password via the web interface for enhanced security on the cRIO-9039.

Installing Software on the cRIO-9039

Troubleshooting the cRIO-9039

Offers solutions for common issues, particularly network communication problems with the cRIO-9039.

Verify the System IP Configuration

Configure the Windows Firewall

Instructions for setting up Windows Firewall exceptions to allow necessary communication with the cRIO-9039.

System Reset

STATUS LED Indicators

Details the meaning of various LED patterns on the cRIO-9039, aiding in status interpretation and troubleshooting.

Where to Go Next