Installing Software on the cRIO-9039
Complete the following steps to install software on the cRIO-9039.
1. In MAX, expand your system under Remote Systems.
2. Right-click Software.
3. Select Add/Remove Software to launch the LabVIEW Real-Time Software Wizard.
Tip You must log in if you set a system password.
4. Select the recommended software set for your LabVIEW and NI-RIO Device Drivers
versions.
5. Click Next.
6. Select NI Scan Engine from the software add-ons.
Select any additional software to install. If you plan on using the cRIO-9039 with the
LabVIEW FPGA Module, you can click Next. Click NI Scan Engine if you plan on
using the cRIO-9039 without the LabVIEW FPGA Module.
Tip You can use this wizard at anytime to install additional software.
7. Click Next.
8. Verify that the summary of software to install is correct.
9. Click Next to start the installation.
10. Click Finish when the installation is complete.
Troubleshooting the cRIO-9039
The cRIO-9039 is Not Communicating with the
Network
• Ensure that the USB connections between the cRIO-9039 and the host computer and the
Ethernet connections between the host computer and the router are secure.
• Configure the IP and other network settings by completing the following steps.
1. Use a USB A-to-B cable to connect the cRIO-9039 USB device port to a host
computer. The USB driver creates a virtual network interface card and assigns an IP
address to the cRIO-9039 in the format of 172.22.11.x.
2. In MAX, expand your system under Remote Systems.
12 | ni.com | NI cRIO-9039 Getting Started Guide
To Next Page
Loading...
Need help?
General
