National Instruments cRIO-9039 - Installing C Series Modules

Sequence cRIO-9039 cRIO-9039 Sync
1 LabVIEW 2014 SP1 or later LabVIEW 2016 or later
2 LabVIEW Real-Time Module
2014 SP1
LabVIEW Real-Time Module 2016 or
later
3 LabVIEW FPGA Module 2014 SP1 or
later
1
LabVIEW FPGA Module 2016 or later
1
4 NI CompactRIO Device Drivers
February 2015 or later
NI CompactRIO Device Drivers August
2016 or later
For minimum software support information, visit ni.com/info and enter the Info Code
swsupport.
Installing C Series Modules
Complete the following steps to install a C Series module.
3
2
2
1
1
LabVIEW FPGA Module is not required when using Scan Interface mode. To program the user-
accessible FPGA on the cRIO-9039, LabVIEW FPGA Module is required.
6 | ni.com | NI cRIO-9039 Getting Started Guide