5-2 | ni.com
Chapter 5 Troubleshooting
tings. Try setting the resolution to 640 × 480 and the refresh rate to 60 Hz. Once you reboot, you
can raise these values again, using the test option in Windows. These settings are accessible
through the Advanced tab of the Display item in the Control Panel. Alternately, you can try a
different monitor, preferably a newer and larger one.
My system boots fine as long as a particular module is not in my chassis.
The most common cause of this is a damaged module. Try the module in a different chassis or
with a different controller. Also, remove any external cables or terminal blocks connected to the
system. If the module does not work in these cases, it is likely damaged. Contact the module
manufacturer for further troubleshooting.
Refer to the KnowledgeBase or product manuals section at
ni.com for more information spe-
cific to the chassis and module with which you are having difficulties.
How do I set Windows to prompt me before shutting down when I press the power button?
Select Start»Control Panel»Power Options to open the Power Options Properties window.
Select Choose what the power buttons do. Under the Power and sleep button settings, use the
drop down menu next to When I press the power button to select from Do nothing, Sleep,
Hibernate, Shut down, or Turn off the display. Click Save Changes.
To Next Page
Loading...
Need help?
General
